DMT Presenter Control Uživatelská příručka stáhnout pdf (Strana 12)

Installation

Remove all packing materials from the Presenter Control. Check that all foam and plastic padding is

removed. Connect all cables.

Set up examples

Programming the device

1. Connect the Computer serial port (52) on the rear panel of the Presenter Control with the

corresponding serial port of your PC/ Laptop using the supplied programming/ communication cable.

2. Connect the Control Panel Port (42) of the Presenter Control with the 9-pin port of the Control Panel

using the supplied programming/ communication cable.

Fig. 5

Controlling a projector with the Presenter Control using the remote terminal

Use a suitable cable between presenter control and projector. For pinning of the Presenter control

connector see appendix 1.

Fig. 6

Controlling a projector with the Presenter Control using IR

Fig. 7

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Žádné komentáře

DMT Presenter Control Uživatelská příručka Strana 12